1. Missed the live Ask the Expert event?
    Catch up on the conversation with Ken Hutcheson, President of U.S. Lawns, in the Franchising forum.

    Dismiss Notice

checking gear case on a 21"

Discussion in 'Lawn Mowing' started by TClawn, Jun 5, 2004.

  1. TClawn

    TClawn LawnSite Silver Member
    Messages: 2,036

    I would like to know how to check and change the gear case lubricant on a 21" toro proline.

    thanks in advance.
  2. Garden Panzer

    Garden Panzer Banned
    from Seattle
    Messages: 313

    Isn't there just zerk fittings? That's what mine has. What happened to Waylon's bar accross from Willies? Did it ever open?
    Last time I was on Maui I got Dengue Fever (sp?)
  3. Craig Jones

    Craig Jones LawnSite Member
    Messages: 120

    We have zerk fittings on our 21" prolines Models 22040,22043 and 22030 but they are for the drive pulley on top and for the wheel gear drive on each side by the wheel adjusters. I believe the transmission case is sealed. We have never taken ours apart and they have a lot of hours on them. However, neglect greasing the wheel gears and they gear drive system will wear out.

    Hope this is of help.
  4. they have used the same trans since the 80ties...lift the bag off a nd you will see a hole in the plastic cover covering where the trans is ...thats were the fitting is..two pumps of the grease gun and you done

Share This Page