Conduit Wall Interface with sealant port - looking for them!!!

Discussion in 'Irrigation' started by EBHC, Jun 18, 2012.

  1. EBHC

    EBHC LawnSite Member
    Messages: 49

    Hello, See the attached photo. This is a very handy 3/4" conduit fitting we use in irrigation and lighting when we run wires through walls. It covers the end of the conduit pipe and the hole we drill for the wire. You can remove the rubber cap and inject some sealant. Its fast, works great and is a very clean looking install. They are also made in 1/2" and white in color.
    My problem is I am about to run out and my local distributor can't get them anymore. They came from a company down in FL. We have made countless attempts to contact the company but have had no luck.
    Does anybody have a source or any info?
    Thanks for your help!

    conduit wall interface with sealant port.JPG

    Messages: 18,668

    I'll call tomorrow the few places I bought them from. Pm me your contact info and I'll shoot you a quick note so you can snatch them up. I used a lot of those myself.
  3. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,764

    Is there no name on the parts? Looks like something easy enough to make a copy of.
  4. greenmonster304

    greenmonster304 LawnSite Gold Member
    Messages: 3,690

    I use LBs for entering and exiting buildings. They allow for a wire to be added later.
    Posted via Mobile Device
  5. Sprinkus

    Sprinkus LawnSite Silver Member
    Messages: 2,327

  6. EBHC

    EBHC LawnSite Member
    Messages: 49

    No name only a patent number
    I looked it up and it was patented to the guy that sold them

    I've tried lb's and don't care for them in the 3/4" and smaller size.
    They require a larger hole in the wall to hide the coupler portion of the box.
    With this unit I can use a smaller hole and cover it quite easy plus it will allow running wires to the full capacity of the pipe because of the gentle sweep into the wall. I always felt the lb restricted wire capacity at the elbow somewhat and was a sharper turn. this unit can be attached w 2 screws no need for a pipe strap. They can easily be taken off to add more wire
    I like em a lot and will continue to use them. Thanks for your input.

    Messages: 18,668

    Plus they are handy in service to clean up a poor wire run into the building. Don't have to pull the wires out and slide them back through into the building. Came in 1/2" 3/4" white and grey colors.
  8. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,764

    I wonder if the guy sold the patent and molds to another company.
  9. Mike Leary

    Mike Leary LawnSite Fanatic
    Messages: 23,174

    Double ditto, never used anything else.
  10. 1idejim

    1idejim LawnSite Fanatic
    Messages: 11,358

    my friends at the warehouse found these in an old catalog, they are called sill plates. no sources though

Share This Page