Discussion in 'Irrigation' started by Dirt Boy, Jun 6, 2006.

  1. Dirt Boy

    Dirt Boy LawnSite Senior Member
    Messages: 496

    Perhaps this is a dumb question:hammerhead: , but; if you have a square area, and wish to have "head to head" coverage, you would typically place a head in each corner.
    My question is this: if you only have a head in 3 of those corners, will the corner without a head still receive adequate coverage? There would still be 2 heads which would cover that area.

    Reason for asking, is owner tends to turn into the driveway and "miss" on occasion, cutting through the area where a head would be located.

  2. PurpHaze

    PurpHaze LawnSite Fanatic
    Messages: 5,496

    The area without a head would be receiving the tail "trace" watering from three sprinklers. Your mileage may vary. :)
  3. Dirty Water

    Dirty Water LawnSite Fanatic
    Messages: 6,794

    We throw into corners often. It works well.
  4. Hank Reardon

    Hank Reardon LawnSite Senior Member
    Messages: 599

    You could put an ABS sleeve slightly above the head for protection.

  5. Keith

    Keith LawnSite Gold Member
    Messages: 3,979

    In trouble areas, around roads and such, we have placed heads inside of half sections of concrete blocks. We just place the head an inch or so below the level of the of the block. In other words, the top of the block will be at the soil level, the head will be sitting at a level an inch lower. Of course, this does you no good whatsoever if this customer is driving over it when it's on :laugh:

    I have on occasion done it with an length of 4" sch 40 pipe in areas where a 6x6" one-inch deep divot with the concrete block would be too large.

Share This Page