Craftsman 6.75 Z-Start Flooding w/Gas

Discussion in 'Mechanic and Repair' started by NoGreenThumb, Apr 30, 2008.

  1. NoGreenThumb

    NoGreenThumb LawnSite Member
    Messages: 1

    I have a 2006 Craftsman B&S 6.75hp Z-Start. Never had a problem until this week. Ran fine last week. Pulls easy and I'm getting spark, however the spark plug is soaked in fuel. Any thougts?
  2. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    Sounds like you may have a piece of trash under the float needle valve, You may need to clean the carb out with carb & choke spray cleaner and see if that solves the problem. If not replace the float needle valve and seat, Also check the oil for fuel contamination and change if so.

    Good Luck

Share This Page