Lawn Care Forum banner
1 - 1 of 1 Posts

· Registered
263 Posts
Discussion Starter · #1 ·
Have you ever checked the actual cutting hieght of your blades on your Z's as compared to the settings on the mower. I find that my Z's a semi new Toro 250 hrs and my old Exmark Z 3200 hrs are both 1/2" off. 3" on the mower adjust scale is actually 2.5" from flat surface to cutting edge. Measurements of deck springs are on spec with service manual. Any thoughts on how to correct this problem or should I just continue to raise the deck up by 1/2" setting to compensate for the error which I've been doing since I've noticed the difference?

Curious minds would like to know! :laugh:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.