1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum.

    Dismiss Notice

Exmark Z no charge

Discussion in 'Mechanic and Repair' started by CT18fireman, May 15, 2002.

  1. CT18fireman

    CT18fireman LawnSite Senior Member
    Messages: 611

    Exmark Z with a Kohler keeps blowing a fuse under the seat by the battery and is not charging the battery. Battery is brand new. When fuse is replaced and engine running it makes good volts but in only a few minutes fuse blows. All connections are clean.

    Any ideas?
  2. Richard Martin

    Richard Martin LawnSite Fanatic
    Messages: 14,699

    I remember there was a post about this a long time ago but I can't remember how to fix it. Post this over in the Exmark Forum for a quick and correct answer.
  3. Jman

    Jman LawnSite Member
    Messages: 217

    Unplug the regulator bolted to the side of the engine. See if your fuse blowing problem goes away. Could be a bad regulator or a shorted stator winding if the fuse no longers blows.
  4. CT18fireman

    CT18fireman LawnSite Senior Member
    Messages: 611

    This is why I run Scags.

    I found the problem. The clutch wires had shorted in the loom. Whenever the clutch was turned on the fuse would blow and the mower would stop charging. Make sense???

    New wire in the loom handled the problem.

Share This Page