1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Exmark

Discussion in 'Lawn Mowing' started by dhenegar, Jul 29, 2000.

  1. dhenegar

    dhenegar LawnSite Member
    Messages: 143

    Has anyone had any problems with the mule drive idler arm not holding grease and rattling. Its the left side of the two big pulleys that turns the blades. <p><p><font size="1">Edited by: dhenegar
     
  2. Richard Martin

    Richard Martin LawnSite Fanatic
    Messages: 14,699

    Since the Lazer Z is a hydro I didn't think it had mule drive anything.
     
  3. Grasscape Inc

    Grasscape Inc LawnSite Member
    Messages: 235

    Mule is the HUGE belt that goes from engine to deck.
     
  4. Keith

    Keith LawnSite Gold Member
    Messages: 3,979

    You are referring to the deck belt, not the mule drive, I think. And the pivot on the arm rather than the pulley. I have a Kees that is very similar and have not had that problem. Most likely there is a bronze bushing or some kind of bushing in the arm that is worn out. Just a guess.
     

Share This Page