Ferris is 3000 electrical problem

Discussion in 'Mechanic and Repair' started by Scott hewitt, Mar 20, 2018.

  1. Scott hewitt

    Scott hewitt LawnSite Member
    Messages: 4

    When I go to turn key to start the mower I just hear click in one of the relays. There is no bolts going to the small plug in wire from key switch. Any help would be appreciated
     
  2. Scott hewitt

    Scott hewitt LawnSite Member
    Messages: 4

  3. dieselss

    dieselss LawnSite Silver Member
    from NWI....
    Messages: 2,137

    Get a wiring diagram, and start looking through the safety switch circuit, then the starting circuit
     
  4. Scott hewitt

    Scott hewitt LawnSite Member
    Messages: 4

    I have done all that every time I turn the key the relays click not the silinoid or starter. There is power going to electric clutch when I pull pto switch the clutch engages. There is also no power going to the small plug on selinoid I just can’t figure it out all safety switches have been tested a two replaced.
     
  5. mlcmvp

    mlcmvp LawnSite Member
    Messages: 23

    Replace the PTO switch. This happened to our IS 2000. Could not figure it out. Ferris dealer replaced switch, good to go!
     
    BigFish likes this.

Share This Page