FS: Hydro Gear Pumps, as Ross Wheel Motors

Discussion in 'Marketplace' started by gtmorgan89, Feb 15, 2010.

Thread Status:
Not open for further replies.
  1. gtmorgan89

    gtmorgan89 LawnSite Senior Member
    from East TN
    Messages: 318

    I've got a few used hydro pumps I have accumulated over the years. These pumps both came off the same mower, and have the same hours on them. The same goes for the wheel motors. The wheel motors are still bolted to the hub, and the frame bracket. The hubs are also the same size as alot of w/b's. They are all in working order and will bolt right up to a lot of Scag, Exmark, and Toro walk behinds.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG][​IMG]
     
  2. OP
    OP
    gtmorgan89

    gtmorgan89 LawnSite Senior Member
    from East TN
    Messages: 318

    I forgot to list that he wheel motors are Ross Torqmotor P/n- mf100933aahu

    Pm me with offers. Im tired of looking at this stuff.
     
  3. OP
    OP
    gtmorgan89

    gtmorgan89 LawnSite Senior Member
    from East TN
    Messages: 318

    Bump. Any offers?
     
  4. mostlyred

    mostlyred LawnSite Member
    Messages: 1

    would you sell just the pumps.any idea how many hours on them?
     
  5. OP
    OP
    gtmorgan89

    gtmorgan89 LawnSite Senior Member
    from East TN
    Messages: 318

    Yes, I can sell just the pumps. I do not have a clue how many hours are on them. Both hold pressure and release valve works as it should. PM me with an offer.
     
  6. cjr

    cjr LawnSite Member
    Messages: 1

    Do you still have pumps? Mf100933aahu
     
  7. rwtrent

    rwtrent LawnSite Member
    Messages: 3

    have you sold the mf100933aahu wheel motors?
     
  8. Squirreling

    Squirreling LawnSite Member
    Messages: 3

    Gtmorgan88, I know this an old post and a long shot but do you have any of the wheel motors still hanging around
     
  9. jrodgers

    jrodgers LawnSite Senior Member
    Messages: 294

    I have a right wheel motor off of a Lesco ZTwo.
     
  10. Squirreling

    Squirreling LawnSite Member
    Messages: 3

    If the part number is the same It doesn't matter what it came off of i don't think.
     
Thread Status:
Not open for further replies.

Share This Page