1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Grease removal

Discussion in 'Mechanic and Repair' started by Mini man, May 17, 2008.

  1. Mini man

    Mini man LawnSite Member
    Messages: 241

    Using my excavator in a wooded area I have gotten all the pretty parts covered in grease smudges from branches leaves etc picking up grease off the boom etc.
    What is the best thing to remove the grease from the sheet metal on my Cat 304.5 CCR?
    Spray 9 maybe?
    :canadaflag::usflag:
     
  2. Breezmeister

    Breezmeister LawnSite Bronze Member
    Male, from South Jersey
    Messages: 1,739

    Brakekleen or Simple Green and a rag :usflag:
     
    ericg likes this.
  3. dutch1

    dutch1 LawnSite Silver Member
    from Jayhawk
    Messages: 2,248

    Super Clean at NAPA, formerly known as Deep Purple. Spray it on then power wash. Warning: don't let it sit on paint for much over a couple of minutes as it can soften as well as dull the paint. I use it all the time to clean up mowers that I have serviced.

    Dutch
     
  4. 44DCNF

    44DCNF LawnSite Bronze Member
    Messages: 1,522

    Fluid Film won't harm paint and will make removal of grease much easier later.
     
  5. dj722000

    dj722000 LawnSite Member
    Messages: 2

    Just take a 1500 PSI hot pressure washer to it. We use them all the time on grease stricken equipment. Takes it right off..
     

Share This Page