1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

GX 160 Bigger Bore

Discussion in 'Mechanic and Repair' started by brendleboxer, Apr 22, 2006.

  1. brendleboxer

    brendleboxer LawnSite Member
    Messages: 6

    I am looking to bore out that GX 160 Honda motor that I posted the crank question on a few days back. I am looking to bore it .75 mm over. My question. Is it worth the time and expense to do it? Will it make a noticeable change? Or is it a waste of time? I am going to use it for a go-Kart motor. Any suggestions or advice will be a great help. Thanks for your time.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    I don't believe you will see that much difference for the money output, But if you must I would only go 0.50 over so you will have at least one more oversize to go before throwing the block away.
     

Share This Page