height of cut range for Toro superrecyclers

Discussion in 'Lawn Mowing' started by brucec32, Oct 22, 2003.

  1. brucec32

    brucec32 LawnSite Platinum Member
    Messages: 4,403

    I have a couple of Toro superrecycler 21" mowers and was curious what the max height adjustment was. I will be mowing some St. Augustine and need to get to 4" if possible. They're stored elsewhere so I need to decide if it's worth the trip to go get them.
  2. TLS

    TLS LawnSite Fanatic
    Messages: 7,943

    Sorry, no personal experience, but I don't know of ANY push mower with a stock cut height over 3.5". Most top out at 3.25".

    I would like to see the following:

    A nice SIMPLE, DEEP (4-5") lightweight aluminum deck, side discharge, 20-22" push mower with a 2 cycle 7hp engine with a 1 Gallon tank, that is capable of a 2" to 4" cut height in 1/4" increments.

    Bagger not needed, but could be an option.

    Self propelled not needed, but could be an option.

    Nice large 2" x 9" steel wheels with greasable bearings.

    Here I go again inventing something that SHOULD be able to be bought at the dealership.
  3. fjhemmer

    fjhemmer LawnSite Member
    Messages: 11

    The height of cut range is 1" through 3.5"

Share This Page