Lawn Care Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12,640 Posts
Hmmm,

Hi,

Is this a small tiller (cultivator). From the hose/filter description, it sounds like a small one with a trimmer/chainsaw motor.
Also, Sticky's last post at the top will give some good ideas on info for me and others to help you.
Numbers Please......

Well.....I'll cut the chase......

Remove the high speed adjuster on the bottom of the bowl, The main jet is behind it. It must be removed before you can pull the top off the carb, But if you only need to get to the jet that can be done as above without removing the carb from the engine or opening the carb....

Good Luck
 

·
Registered
Joined
·
294 Posts
Discussion Starter · #3 ·
Hmmm,

Numbers Please......

Well.....I'll cut the chase......

Remove the high speed adjuster on the bottom of the bowl, The main jet is behind it. It must be removed before you can pull the top off the carb, But if you only need to get to the jet that can be done as above without removing the carb from the engine or opening the carb....

Good Luck
Thanks, I drew a blank until a little later. All I could remember was that I had modified a screwdriver to fit.

On another thread I was asked what the trick was. Thanks again
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top