1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Help exmark lazer z 52" 27 hp deck clogging

Discussion in 'Lawn Mowing Equipment' started by fireofficer001, Jul 21, 2014.

  1. fireofficer001

    fireofficer001 LawnSite Member
    Messages: 3

    When it dry out as I am cutting it leaving grass lines, then I remove the tube and bang on the top of the ultra vac 10 times when running and then it un clogs . Please any advise would help. I was told low lift blades and remove the deck and clean and paint the underneath. Is this it and does this system work, And is it the deck that clogging , Pat
     
    Last edited: Jul 21, 2014
  2. trock

    trock LawnSite Senior Member
    Messages: 431

    How is the blade inside the ultra vac? Check to see if its worn. Also make sure the screens and the bags are clean and can breath properly
     
  3. fireofficer001

    fireofficer001 LawnSite Member
    Messages: 3

    the screens are fine and I will check the blade in the ultra vac. Bag cleaning ? should I pressure wash them
     
  4. trock

    trock LawnSite Senior Member
    Messages: 431

    Yea sometimes the little holes in the bags get plugged up causing it to loose vacuum
     
  5. trock

    trock LawnSite Senior Member
    Messages: 431

    Yes we power wash ours all the time
     
  6. fireofficer001

    fireofficer001 LawnSite Member
    Messages: 3

    ok great info thx
     

Share This Page