1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Help Needed on 1992 Hustler 3400

Discussion in 'Hustler Turf Equip (Archived)' started by paulver, Apr 30, 2008.

  1. paulver

    paulver LawnSite Member
    Messages: 12

    I have a warped flywheel on a 4300. The engine is a Ford VSG 411i w/electronic ignition. The flywheel has a five bolt pattern and isn't made anymore. I've had it ground down to take a good bit of the wobble out, but it still breaks the stub shaft. I'm affraid to take any more off for fear of breaking the flywheel altogether. Can anyone help me out here? Any info is appreciated.

    Thanks.

    Paul
     
  2. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Messages: 9,769

    Thats a tough one...
    I am not aware of any.
    I will however email a guy that may have a dealer or 2 you can call that might have some old units.

    Pj
     
  3. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Messages: 9,769

    Some quick info from our parts manager...

    There are two choices for this, you would have to measure the clutch stub shaft diameter, if the stub shaft measures 8.50" then the Ford part number would be 77BM-6375-CA If it measures 9.50" then the Ford part number is 81BM-6375-AA.
    Contact Kansas City Power Products 800-486-5277, they are a Ford industrial engine parts distributor and would be your best bet.
     

Share This Page