1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

How do you maintain beveled edges when cutting pavers?

Discussion in 'Hardscaping' started by 4 seasons lawn&land, Oct 24, 2009.

  1. 4 seasons lawn&land

    4 seasons lawn&land LawnSite Gold Member
    from NY
    Messages: 3,613

    One thing I dont get when looking at pictures of jobs with the full width curved is how they sometimes dont show that sharp edge where they were cut. They are fit tight, not curved by opening the gaps yet still maintain the factory beveled edges. Just something id like to understand.
     
  2. zedosix

    zedosix LawnSite Silver Member
    Messages: 2,665

    We sometimes chip the edges of the radius brick to make it look natural rather than have the sharp edge.
     
  3. White Gardens

    White Gardens LawnSite Fanatic
    Messages: 6,776

    If it's a tumbled paver then I do as stated above, just use a hammer to make it rustic.

    If it's a clean paver, no tumble, then you might be able to put a little bevel on the paver with an angle grinder with a diamond blade. Not sure how well that would work though.
     

Share This Page