1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

how to lay out radius

Discussion in 'Hardscaping' started by treemover, Jan 19, 2014.

Thread Status:
Not open for further replies.
  1. treemover

    treemover LawnSite Senior Member
    Messages: 418

    doing a 'seawall' on a pond. whats a good to layout the radius? the center point is in 6' ft of water
     
  2. zedosix

    zedosix LawnSite Silver Member
    Messages: 2,665

    A 7' stick.
     
  3. treemover

    treemover LawnSite Senior Member
    Messages: 418

    And a boat
    Posted via Mobile Device
     
  4. alldayrj

    alldayrj LawnSite Gold Member
    Messages: 3,793

    And a string
    And a can of marking paint
    Posted via Mobile Device
     
  5. treemover

    treemover LawnSite Senior Member
    Messages: 418

    This was worth my time typing....
    Posted via Mobile Device
     
  6. zedosix

    zedosix LawnSite Silver Member
    Messages: 2,665

    Wait til the pond freezes.
     
  7. whiffyspark

    whiffyspark LawnSite Fanatic
    Messages: 6,287

    What did you expect for an answer lol
    Posted via Mobile Device
     
  8. treemover

    treemover LawnSite Senior Member
    Messages: 418

    An actually answer
    Posted via Mobile Device
     
  9. whiffyspark

    whiffyspark LawnSite Fanatic
    Messages: 6,287

    Youre asking how to measure from a middle of a 6 foot deep pond.

    You could probably run string lines in an x to find the center of the pond.
    Posted via Mobile Device
     
  10. treemover

    treemover LawnSite Senior Member
    Messages: 418

    I have to build a radius wall around an end of a pond. When we usually lay out a radius, we use the center point as one point of reference. Since the center point is in the middle of water, I am wanting other ideas or procedures to lay out the radi correctly
    Posted via Mobile Device
     
Thread Status:
Not open for further replies.

Share This Page