1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum.

    Dismiss Notice

How to remove broke exhaust stud?

Discussion in 'Mechanic and Repair' started by Milwaukee, May 25, 2010.

  1. poncho62

    poncho62 LawnSite Member
    Messages: 222

    for KEY...RISE....T....sake, I will repeat......

  2. Ruben Rocha

    Ruben Rocha LawnSite Senior Member
    Messages: 577

    Might work. Sometimes kinda sorta maybe.
    I would sure try it before I go through the rest of it.
  3. PTP

    PTP LawnSite Bronze Member
    from Tulsa
    Messages: 1,398

    Yes, what Poncho said will work. If you can get some sort of grip on the bot with vice grips or something like that, you can even skip the "weld a nut on it" part. Get it hot - cherry red hot - and turn it out.

    However, you need to be careful because you have been putting a lot of oil in that area. Don't set the thing on fire.

    METRO FS LawnSite Member
    Messages: 48

    Actually, in some cases, there is a solution for this problem. There are replacement studs that are manufactured with a hole down through the center. This stud is held in place on the end of the old one and then you slide the wire on a wire welder up through the hole and pull the trigger to weld the new stud to the old one. Had it done once about 10 years ago. I'm sure they are still available. Good luck!

Share This Page