1. Missed the live Ask the Expert event?
    Catch up on the conversation about enhanced efficiency fertilizers with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

Hunter Pro-C Error?

Discussion in 'Irrigation' started by HLM86, Jun 18, 2008.

  1. HLM86

    HLM86 LawnSite Member
    Messages: 120

    Hunter Pro-C box, 11 zones. Zones 7 & 10 (rotars) read "Err" and will not run. Any ideas about whats goin on here? Thanks.
     
  2. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 48,932

    Howzabout bad solenoids?
     
  3. SprinklerGuy

    SprinklerGuy LawnSite Bronze Member
    Messages: 1,778

    Ditto............
     
  4. AI Inc

    AI Inc LawnSite Fanatic
    Messages: 25,755

    May just be a loose wire at the solonoid or cut wire . Is 7 and 10 on the same controll wire ? Could be a problem with the common on that run.
     
  5. jimmyburg

    jimmyburg LawnSite Senior Member
    Messages: 701

    slide the module in and out again, and lock down you might have a bad one.
     
  6. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 48,932

    ....and check the blinker fluid....
     
  7. Without A Drought

    Without A Drought LawnSite Bronze Member
    Messages: 1,045

    check the solenoid on those valves. not to compound the troubleshooting, but occasionally i'll get errors on multiple zones and it turns out to be the master valve. if there is one, pull the MV wire at the timer and run through gain to check for any errors.

    pg
     
  8. jimmyburg

    jimmyburg LawnSite Senior Member
    Messages: 701


    :laugh::laugh::laugh:
     
  9. HLM86

    HLM86 LawnSite Member
    Messages: 120

    Thanks guys. I'll be looking into it tomorrow.
     

Share This Page