1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Hustler Super Z hydro pumps

Discussion in 'Mechanic and Repair' started by tjcezar, Feb 1, 2013.

  1. tjcezar

    tjcezar LawnSite Member
    from PA
    Messages: 237

    I have a Hustler Super Z XR 7 that the top caps on the hydro pumps were leaking. When I removed the cap the o ring looked flat and square but the dealer said they used to be round. They gave me new round ones and I installed and tightened everything back up. Started er up and worked the levers and they both started leaking bad right away. I then toiok the one side back off just to check that the oring was ok but everything looked good so I reassembles and tried it again. This time nothing worked. Does the system need to be bled somehow?
     
  2. ricky86

    ricky86 LawnSite Silver Member
    Messages: 2,074

    Some of the seals WERE quad rings. I have installed the wrong one once. Easy to mix up without really looking at them. I never had a leak. In fact I don't think I've ever seen a charge pump leak. What I encountered was the pump could not prime itself. (Hope you got the old one.) If you just removed the charge pump cover, and put the check valve and cover back correctly, it should prime its self in less than 4-5 minutes tops.
     

Share This Page