1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum.

    Dismiss Notice

Hustler Z Grease fittings

Discussion in 'Hustler Turf Equip (Archived)' started by chad7480, Aug 28, 2006.

  1. chad7480

    chad7480 LawnSite Member
    Messages: 1

    I just bought a 2006 Hustler Z 60" with a 23hp Kaw. I was looking through the manual for greasing locations and the spots that it shows to grease do not seem to have grease fittings. The only grease fittings I found were the ones on the front tires.....Is there something I am missing here? Any help or advice would be greatly appreciated.

    Thanks in advance,

  2. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Messages: 9,769

    They are there, look closely, the 4 pivot point for the deck lift are on the bottom side, and the idler arm for the hydro belt is under there a bit also.
    The 2 for the deck pusher assembly are accessed from under the seat.
    Hope this helps.

  3. JimmyJ

    JimmyJ LawnSite Member
    Messages: 20

    The Z has 10 grease points not counting the spindles. Two have to be accessed from the rear underneath the engine. I have a set of the plastic ramps that you use to change oil with and I back my mower up on it to reach the two fittings under the engine.

Share This Page