1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

I got a problem!!

Discussion in 'Landscape Architecture and Design' started by CleanCutMowers, Jul 29, 2007.

  1. CleanCutMowers

    CleanCutMowers LawnSite Member
    from SE MO
    Messages: 150

    I am guessing this is a newbie mistake but I have an Exmark Phazer. I go to reinstall my blades and when I go to tighten them down it will tighten tight and the other side is also moving. I put a block in and all and they will just not sinch down. What do I need to do. I change them every couple days and never have had this problem. Thanks!
     
  2. Vikings

    Vikings LawnSite Bronze Member
    from canada
    Messages: 1,657

    I'm not sure I understand your problem but an impact wrench makes switching my blades a whole lot easier, I don't have to hold both the nut and the bolt, it just flys off.
     

Share This Page