Installing/removing Exmark mulch kit

Discussion in 'eXmark' started by bigjeeping, May 8, 2006.

  1. bigjeeping

    bigjeeping LawnSite Senior Member
    Messages: 903


    When I purchased my 50" HP and 44" phazer last month I had the dealer install mulch kits on both. Well, I decided I'd like them off until the growing season slows down. How do I take them off? I got under the deck on the HP and couldn't figure it out...... was there welding involved to install it?
  2. eXmark

    eXmark Manufacturer / Sponsor
    Messages: 4,258


    There's no welding involved, but without an instruction sheet, I'd imagine it'd be a little tricky to figure out. With the attached instruction sheet, I'm sure you'll be able to get it.

    For anybody else, this is the instruction sheet for all of the new Tritons.

    If you have any questions, don't hesitate to contact us again.



    Attached Files:

  3. brucec32

    brucec32 LawnSite Platinum Member
    Messages: 4,403

    Looking at the schematic, all I can say is... I guess you guys didn't go with my "we need mulch kits that are easier to change" feedback! 16 plus bolts/screws and 7 or so parts. Wow.
  4. 3Bladz

    3Bladz LawnSite Member
    from IL
    Messages: 166

    On John Deere you pull a lever.

Share This Page