Lawn Care Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
252 Posts
Discussion Starter · #1 ·
We received one of two bids today for our irrigation installation for our parish campus. We're interested in the front of the property as highlighted in the plot of survey attached.

Suggestions include:

Rotary Heads - Hunter PGP Gear Drive
Spray heads - Rainbird 1800 Series
Electrical Valves - Irritrol 2400 Series
Controller - Pro-C
Interior pip - Copper 1"
Underground pipe - Polyethylene/PVC

Is this adequate for church/school grounds? Any problems with foot traffic, snow plows, etc.?

 

·
Registered
Joined
·
659 Posts
Suggestions include:

Rotary Heads - Hunter PGP Gear Drive

spend the extra cash and get hunter i 20

Spray heads - Rainbird 1800 Series

i like hunter pro spray with rainbird nozzles...just me.

Electrical Valves - Irritrol 2400 Series

go for hunter jar tops...irritrol solenoids burn out too fast too frequently

Controller - Pro-C

can't go wrong with a pro c

Interior pip - Copper 1"

sounds good...put a watts 800 m4 backflow or rpz...pvb more cost effective.

Underground pipe - Polyethylene/PVC

poly pipe for heads, pvc from back flow to manifold.

below, i have the same type of system installed here...i did not design, but our company installed it. check it out. works good, no?

Cloud Sky Daytime Water Plant
 

·
Banned
Joined
·
1,712 Posts
Hunter I20 rotors and Institutional series spray heads. Water proof wire connections with no underground splices. Only splice at valves. Matched precipitation nozzles on rotor heads. Head to head coverage.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top