1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

John Deere 21S trimmer

Discussion in 'Mechanic and Repair' started by MWHC, Aug 8, 2011.

  1. MWHC

    MWHC LawnSite Member
    from Wyoming
    Messages: 213

    We have a JD 21S trimmer giving me fits. The trimmer was running fine and stopped running. Have changed the plug, coil, fuel lines and cleaned the carb. I cant even make it pop. The compression is good. I do notice a lot of fues coming out of the muffler when I am pulling it a lot. Any Ideas where to look next?

    Thanks.
     
  2. dutch1

    dutch1 LawnSite Silver Member
    from Jayhawk
    Messages: 2,248

    I'm not familiar with the JD line so I don't know with what they might use for an antispark screen. It's possible that the screen may be carbon blocked. Remove the screen, if one exists, and burn the carbon from it with a torch. If this is the case, try starting the unit.

    If you're convinced that the compression is adequate, confirm that you have spark at the plug. The most convenient is an in line spark checker. In the absence of a spark checker, first remove the plug and isolate the plug wire so that it will not create a spark around the spark plug port--you may have built up fuel in the cylinder as well as the crank case. Turn the engine upside down and crank the engine several times to assure that there is no excess fuel present then blow out cylinder and plug.

    Reinstall, plug on plug wire and hold the plug base against the block, crank and check for spark. If spark is present, give the engine a shot of brake cleaner through the carb and determine if the unit will fire up for a brief time.

    From your description, it is apparent that you're getting fuel and more than likely over fueling, possibly a result of the inlet needle not holding, a faulty check valve in the primer body or carb diagphrams with leaks.
     
    hort101 likes this.
  3. dutch1

    dutch1 LawnSite Silver Member
    from Jayhawk
    Messages: 2,248

  4. MWHC

    MWHC LawnSite Member
    from Wyoming
    Messages: 213

    Thanks. I will check the exhaust. This John Deere unit was made by Echo.
    I have tried the carb cleaner in the spark plug and still cant get it to fire for a second. It has spark according to the inline check.
     
  5. tallfarmboy

    tallfarmboy LawnSite Member
    Messages: 25

    Digging up an old thread... LOL by chance was the flywheel key sheared?
     

Share This Page