1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

John Deere RX75 speed problems

Discussion in 'Mechanic and Repair' started by GardenPrairie610, Jun 22, 2010.

Thread Status:
Not open for further replies.
  1. joe billy

    joe billy LawnSite Member
    Messages: 35

    Jeez , just how many RX 75's did they make ?
    Are they all still running ?

    Try sending a PM. to one of the hundred people that thanked RestroRob for the manual..
    They might be kind enough to send you a copy.
    Posted via Mobile Device
     
  2. Honda3813

    Honda3813 LawnSite Member
    Messages: 3

    Sounds good. Thanks for the help

    Regards,

    Sean
     
  3. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029


    joe billy..... One must have at-least 10 post count and be a member X amount (I forgot) of time before PM privileges are enabled.....
     
  4. Honda3813

    Honda3813 LawnSite Member
    Messages: 3

    Thanks for the offer Jay..

    I replied to your message but not sure if it got to you. I will keep your email offsite as you asked... I'll post my work email to send info.. telstar@gate.net

    Thanks again!

    Sean
     
  5. joe billy

    joe billy LawnSite Member
    Messages: 35

    Thanx RestroRob.
    Just trying to help.
    Must have missed it in the fine print.
    Posted via Mobile Device
     
  6. rx75

    rx75 LawnSite Member
    Messages: 10

    That explains it! I looked all over in the hopes of finding a way to send a PM. LMAO! Maybe someday I'll get my PM privileges.
    RX75

     
  7. piston slapper

    piston slapper LawnSite Platinum Member
    Messages: 4,329

    Check your pm,s
     
  8. flatback1986

    flatback1986 LawnSite Member
    Messages: 1

    Hello Rob, I would also like a copy of the RX75 manual. Thanks Tim
     
  9. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    Sorry Tim, This is posted on the previous page;


     
Thread Status:
Not open for further replies.

Share This Page