Kohler efi swap

OP
T

Tpaul71

LawnSite Member
Yes i used the original motor but swapped parts from carb motor and took all efi off. I'm trying to figure out about solenoid on carb where to run wire and the kill switches on the swapped coils wher to run wires from??
 
OP
T

Tpaul71

LawnSite Member
Also I can't seem to make engine idle low . I have adjusted governor and it still runs high rpms!
 

JoeRagMan

LawnSite Senior Member
Location
Near TMI
Solenoid should be powered from the “run” wire at the ignition switch. Coil kill wire should be wired through the safety switch circuit. As far as the governor problem, I would think the linkage/ spring adjustment is critical. Possibly check engine manufacturer’s webpage for any help. Good luck.
 

Top