Lawn Care Forum banner
1 - 3 of 3 Posts

· Registered
88 Posts
Discussion Starter · #1 ·
I had to replace the piston on my lawn solutions stand on aerator because the seal was leaking but now when I put it in, the lower attachment for the hydraulic line hits the hydro motor and I can't figure out how to adjust it so that it does not.
Green Plumbing Water Gas Automotive tire
Automotive tire Hood Motor vehicle Circuit component Gas
Does anyone have any suggestions?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.