1. Missed the live Ask the Expert event?
    Catch up on the conversation about enhanced efficiency fertilizers with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

Lazer Z blades engage after a 15 second delay.

Discussion in 'Mechanic and Repair' started by CharlieBingo, Oct 28, 2005.

  1. CharlieBingo

    CharlieBingo LawnSite Senior Member
    Messages: 400

    When I engage my blade switch nothing, once I go forward about 25ft they pop on any ideas? As always thanks in advance.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,028

    I'm not familiar with the Lazer line but you may check for a relay going bad or if you have a adjustable style pto clutch checking the air gap.
    Maybe this will help.

    Good luck
     
  3. Bret's Lawn Care

    Bret's Lawn Care LawnSite Member
    Messages: 122

    Check the gap of the clutch
     
  4. TLS

    TLS LawnSite Fanatic
    Messages: 7,941

    Try replacing the switch first. They do go bad, and can cause what your experiencing.

    If all else checks out (wires all tight, etc) you'll likely need a new clutch.

    But, like I said, try the switch first.
     
  5. DEEJ

    DEEJ LawnSite Member
    Messages: 230

    On one of the small tractors I have, the oversized headlights will draw down the battery if I run them too long. The electric clutch is fine with this as long as it remains on. If I turn the clutch off and try to engage it again when the battery voltage is a bit low, there is a huge delay before it comes back on.

    So, is the battery voltage low for some reason? is the charging circuit working correctly. Or, as in my case, is some other accessory drawing down the battery?

    deej
     

Share This Page