1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Lincoln plasma cutter troubleshooting

Discussion in '<a href=http://www.lawnsite.com/buttons/jump.php?i' started by IH Cub Cadet, Sep 11, 2003.

  1. IH Cub Cadet

    IH Cub Cadet LawnSite Member
    from Indiana
    Messages: 8

    I have just started using a Lincoln ProCut 60 plasma cutting system. I have having some trouble getting a high quality cut in only .125 mild steel. The air pressure is set to sixty, but would it help to turn it up a bit. According to the manual, you can turn it up, but not exceed 120 psi. I am also using a straight edge.
  2. vipermanz

    vipermanz LawnSite Bronze Member
    Messages: 1,773

    tried changing the electrode and nozzle?? what's your standoff when cutting
  3. BSDeality

    BSDeality LawnSite Silver Member
    Messages: 2,849

    is it cutting out? If thats the case, you've got a bad ground, or possibly water in the CO2. add a water filter if you don't already have one on the compressor.
  4. Rob T

    Rob T LawnSite Member
    Messages: 165

    Can u turn the amperage down on your machine? Mine cuts thin sheet better on the lowest setting.

Share This Page