Metro Transmission Belt

Discussion in 'eXmark' started by myeager, Jun 19, 2006.

  1. myeager

    myeager LawnSite Member
    Messages: 13

    Hi. The transmission belt on my Metro began slipping off. When I looked at the belt, it was damaged, peeling away in about a 3 inch section. The belt is in good shape (not worn) except for the portion that is damaged.

    I can replace the belt without much of a problem, but my question is what would cause belt damage like that?
  2. mcwlandscaping

    mcwlandscaping LawnSite Gold Member
    Messages: 3,163

    could you have spilled some kind of solvent on that part of the belt or something like that?
  3. tallimeca

    tallimeca LawnSite Bronze Member
    Messages: 1,229

    usually if you get belt wear on the back, the belt could be contacting a belt guide, the back side idler bearing could be failing, or debris could have gotten in contact with the belt.

    New belts are cheap. 1-323280 is the part number i think.

Share This Page