MP Rotator vs Single Stream Rotor

Discussion in 'Irrigation' started by txirrigation, Aug 6, 2011.

  1. FIMCO-MEISTER

    FIMCO-MEISTER Banned
    Messages: 18,668

    or this. remember when kids went outside and played?
     
  2. Kiril

    Kiril LawnSite Fanatic
    Messages: 18,334

    Agreed

    > 25 feet .... agreed

    Agreed, assuming a standard rotor is appropriate

    Absolutely agreed.
     
  3. Kiril

    Kiril LawnSite Fanatic
    Messages: 18,334

    I didn't say the whole state ... did I? Maybe you should check a climate map sometime TXI.
     
  4. txirrigation

    txirrigation LawnSite Senior Member
    from Texas
    Messages: 977

    Agreed! Here we are in this little moment when we agree with each other!

    Dont read my post about Cali's bank roll, our little moment will be short lived.
     
  5. FIMCO-MEISTER

    FIMCO-MEISTER Banned
    Messages: 18,668

    Praise the Lord. Now lets move on to the Israeli/Arab conflict.
     
  6. Kiril

    Kiril LawnSite Fanatic
    Messages: 18,334

    I could care less what the financial status of this state is ... however don't let that stop you and Pete from pulling the typical Texan "we are better then everyone else" attitude.

    Oh ... and here is your climate map.

    [​IMG]
     
  7. FIMCO-MEISTER

    FIMCO-MEISTER Banned
    Messages: 18,668

    Oh my Gawd. What an amazing map! I have so much respect for you now.
     
  8. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,386

    lets get back to the water wiggle commercial - notice the 'lawn hydrant' the hose was connected to?
     
  9. FIMCO-MEISTER

    FIMCO-MEISTER Banned
    Messages: 18,668

    looks like a galvanized pipe with one of those angled boiler drain screwed on right at the curb? Did i miss something?
     
  10. AI Inc

    AI Inc LawnSite Fanatic
    Messages: 26,818

    I dont know about low pressure and MP,s . From my limited experiance with them , they dont need a lot of water , but sure do like pressure.
     

Share This Page