1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Need Help.... Fast

Discussion in 'Lawn Mowing' started by 04TurfT, Apr 29, 2006.

  1. 04TurfT

    04TurfT LawnSite Senior Member
    Messages: 255

    I was changing my blades today and 2 of em came off real easy... the other one I can't get off... When I put a wrench on both sides it turns, but the gold bolt that goes through the pulley and all that starts to turn. The blade bolt usually comes off but it aint werkin.. any suggestions maybe I should try it with air tools????
     
  2. Splicer

    Splicer LawnSite Senior Member
    Messages: 992

    Impact ...
     
  3. JTF40

    JTF40 LawnSite Senior Member
    Messages: 875

    Ditto....:usflag:
     
  4. Lumberjack

    Lumberjack LawnSite Member
    Messages: 180

    If you dont have an impact handy you have to stop the top pulley from turning. some have holes/spokes you can cram a sturdy screwdriver thru. If your still out of luck remove the belt and try a strap wrench.
     
  5. Green Acres

    Green Acres LawnSite Senior Member
    Messages: 316

    I had one stuck the other day I used the cutting torch and heated it up a little. It worked fine just don't heat if for very long. Actually I did two of them like that.
     
  6. CutInEdge Lawn Care

    CutInEdge Lawn Care LawnSite Senior Member
    Messages: 677

    When you get that bolt off do not put bk on till you use some anti-seize from local automotive store. Will save you some time. I have to use on the non-discharge side or I can really fight the bolt and I use 1/2" impacts. Good Luck!!!
     

Share This Page