1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Nelson EZ Pro Jr Problem / Question

Discussion in 'Irrigation' started by MEXANDME, Aug 30, 2011.

  1. MEXANDME

    MEXANDME LawnSite Senior Member
    Messages: 396

    I have a customer with the above clock.

    Twice now she has called with with a zone running continiously and turning off the clock does not stop it but unplugging the clock does stop it.

    Just to be sure, I have looked at the clock twice and I can not find anything wrong with the programming. I have not been there while it is running and I cannot get it to do it when I am there.

    But, since unplugging the clock stops the zone from running, doesn't this have to be a clock problem?

    Thanks !!!!

    Mex
     
  2. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,267

    Buy a new controller
     
  3. SoCalLandscapeMgmt

    SoCalLandscapeMgmt LawnSite Silver Member
    Messages: 2,117

    sounds like something is causing one of the shift registers in the output circuitry to hang..... given that it's a fairly cheap controller I'd just tell the client that they are better off replacing it.
     
  4. FIMCO-MEISTER

    FIMCO-MEISTER Banned
    Messages: 18,668

    Man that shift register in the output circuitry was always a biatch to deal with. I always replaced the controllers that did that one to me.
     

Share This Page