New Super Z, Tire Pressure?

Discussion in 'Hustler Turf Equip (Archived)' started by DESTEFANO3782, Jun 25, 2006.

  1. DESTEFANO3782

    DESTEFANO3782 LawnSite Member
    Messages: 44

    I Have A Super Z Xr-7 With The Flex Forks And A Bac-vac. What Should My Front And Rear Tire Pressure Be? My Dealer Says 7-10lbs But It Seems Way To Low, Any Help Would Be Appreciated.
  2. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Messages: 9,769

    We do not recommend Flex Forks with the Bac-Vac.
    Tire pressures should be between 8-12 PSI depending on your conditions.
    Of course with a hopper full of grass your pressures should be a bit higher in the rear.
    I would start them higher and adjust them to what works best for you.

  3. DESTEFANO3782

    DESTEFANO3782 LawnSite Member
    Messages: 44

    I Can See Why U Dont Recommend The Forks, Becuase I Am Scalping Lawns Up Like Crazy. I Am Disappointed That My Dealer Wasnt Smart Enough To Advice Me Of The Right Set Up To Get
  4. puppypaws

    puppypaws LawnSite Fanatic
    Messages: 9,163

    The more weight you put on the back the more it will cause the flex forks to bob up and down like a fishing cork, it would be like putting a ton of sand in a half ton pickup and riding across your yard and expecting it to not go up and down. The flex forks are designed to have a certain amount of down pressure on the front of the mower so they can perform correctly, when you change that balance it voids the design they were engineered for.

Share This Page