Separate names with a comma.
Can’t make it to the GIE+EXPO 2017?
LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.
Discussion in 'Hustler Turf Equip (Archived)' started by T-N-T, May 8, 2006.
E-mail me please.
I bought a used 06 Hustler 60" mower with the xr7 deck and it only has 400hrs on it. I want to know if there is still a way to get the triangle kit cause this mower is driving me crazy leaving that streak of grass between the left and center blade.I am going broke double cutting everything or either mowing at a snails pace trying to get it to cut everything
Talked to my dealer and he told me since the mower was out of warranty and I was not the original owner then I would have to pay for the part myself.I do not understand why I have to pay for a manufacturers design problem?
What is your serial #?
it seems to me the part should have been installed from the factory cause I had to drill no holes on mine.They were pre drilled on both sides.I buy all my stuff from Right of Way equipment in Raleigh.I had to go ahead and buy the part cause it was killing me to keep mowing at a snails pace.They said if there is a way to work it out between you guys then they would refund me my money I had to pay.LMK please.Thanks Nick
so have you found out anything?
Could you send me an email and we can go over the details?
I have a 2007 66" Super Z that is experiencing the same problem of leaving an uncut strip of grass between the left and center blades in heavy grass. Here are the model and serial numbers:
On this thread I see there is a triangle baffle kit Hustler P/N 107897 that addresses this problem. Is this still available? If so, where can I get it?
Any help would be appreciated because my customers noticed it and double cutting is really hurting productivity.
The triangle baffle kit 107897 still shows up in our price list. This kit was mostly used on northern grasses while using the first generation of XR-7 decks. Or "A" deck like what you have. If you have checked for straight blades, straight deck, right deck pitch, loosen and push the spindles towards each other prior to torquing etc. you may want to try the kit. I just wouldn't start there.