1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Oil Change

Discussion in 'Mechanic and Repair' started by RBall151, Jun 30, 2004.

  1. RBall151

    RBall151 LawnSite Member
    from KS
    Messages: 40

    Hey -
    I bought a 36" Toro Eaglestar Walk Behind Mower. It's got a Kawasaki FB460V engine on it, and my question is how many quartz of oil do I need to to put in it?

    I was told between 1 and 1 1/2 of 10W30 Oil. I drained the oil, and just want to get a second opinion.


    I might end up just buying the owners manual, since I dont know about the Oil Filter, Gas Filter and Air Filters and when to replace them.


    Any advice?

    Thanks
     
  2. MattG

    MattG LawnSite Member
    from STL, MO
    Messages: 13

    I have the 14horse Kaw. It takes right around 1.5 quarts. I add one full quart, then about 1/4, checking after each quarter. Once its in the "full" range on the dip stick, I run it for a little while to to get the oil around the system. After sitting I check it again and add as needed.

    FYI- I pre fill the filter to reduce the pressure lag.
     
  3. bobcat175

    bobcat175 LawnSite Senior Member
    Messages: 377

    with filter the oil cap on that engine should be : 1.4 liters or 47.4 fl.oz., or 1.479 quarts
     

Share This Page