PTO Im looking for The one I took off is a OGURA M-GT-TROC trying to find another one

Discussion in 'Lawn Mowing Equipment' started by videorov, Jul 23, 2019.

  1. videorov

    videorov LawnSite Member
    Messages: 14

    Its for a Toro Groundmaster 120 Model 30612 serial 890142

    The old one I just took off is in the pictures I posted.

    DSCF6187.JPG

    DSCF6186.JPG
     
  2. hal

    hal LawnSite Bronze Member
    from Georgia
    Messages: 1,892

  3. OP
    OP
    videorov

    videorov LawnSite Member
    Messages: 14

    I have foound that the extreme Fat boys don't work for the GroundMaster 120 because you can get them to fit behind the frame to slide them onto the shaft. The pulley is to thick and to wide. Yes Pats small engines I think might have what I need. The one on ebay if pretty high priced for $445 I have bout them for less. Thanks for the links.

    I wish the Extreme did fit because their prices are low. But its a tight fit on the Groundmaster 120 to get
    the clutch in between the frame and the shaft to install it.
     
    Last edited: Jul 23, 2019
  4. hal

    hal LawnSite Bronze Member
    from Georgia
    Messages: 1,892

    Jthomas, partstree, are a couple more
     
  5. OP
    OP
    videorov

    videorov LawnSite Member
    Messages: 14

    jThomas I ordered one from them but its wrong and had the square key already inside the the pulley welded. I need the version with the notch so it can slide over the square key on the shaft :) I had to send that one back. Always something:)
     

Share This Page