Rainbird esp-6tm no output power

Discussion in 'Irrigation' started by david28, Jun 6, 2007.

  1. david28

    david28 LawnSite Member
    Messages: 2

    I need your help! I have a Rainbird ESP-6TM Controller. The Sprinkler heads don't popout with water. The controller has power but the output power is always 0. Fuse is also good. I also used the spare fuse. I tried to remove the battery to reset, but it did not work. Any suggestions? Thanks in advance for all of your help!
    By the way, my house got some T-storms as well as power interruptions recently.
  2. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,758

    Allow for the possibility of a dead controller.
  3. Mike Leary

    Mike Leary LawnSite Fanatic
    Messages: 23,172

    Storms (or garage door openers) can do a number on these clocks. Pull the
    battery, unplug from wall...wait overnight. They DO have surge protection,
    but I've fried a lot of clocks that had protection, also. The transformer is
    probably fine, but the surge creeped in the "back door". The pros in lightning
    prone areas use 14 gauge wire with multiple loops to absorb the "hit". A new
    clock is probably cheaper than the repair.:cry:
  4. david28

    david28 LawnSite Member
    Messages: 2

    Thank you for your quick replies!!

Share This Page