1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

rings for walker kohler20

Discussion in 'Mechanic and Repair' started by dobe, Aug 30, 2009.

  1. dobe

    dobe LawnSite Member
    from VA
    Messages: 34

    Is there a place I can order rings and head gaskets etc for a kohler 20hp motor in a walker mt?
    Pretty sure my rings are worned out and i think I have a blown head gasket on one side.

    thanks
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

  3. dobe

    dobe LawnSite Member
    from VA
    Messages: 34


    used google all night but cant seem to find the rings for the ch20 for walker
    tewarehouse don't list them for that motor.

    the rcpw.com looks like they might have it if I had the part number, and I dont.
     
  4. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029


    Forget about the above part, Post the Spec number off this engine.
     
  5. dobe

    dobe LawnSite Member
    from VA
    Messages: 34

    must have too much dirt on the motor every sticker i found wont the right one.

    where is it normally at on the ch20's? not in the same place as my cv
     
  6. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    There should be a white decal on the flywheel cover near the top.....
     
  7. dobe

    dobe LawnSite Member
    from VA
    Messages: 34

    im outside now cleaning it off, should know something soon.
     
  8. dobe

    dobe LawnSite Member
    from VA
    Messages: 34

    that sticker is not there anymore. its got 17XX hrs on it so who knows.

    anything else i can look for?
     
  9. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    Dinner bell just rang....Back shortly.....
     
  10. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    OK,

    If this engine has the drive pulley on the flywheel side with no shaft sticking out of the other side we can assume this isn't a "Basic" engine.

    If that's the case there are only seven engines listed for Walker units, All ring part numbers on these engines supersede to new numbers as listed below;

    Rings STD; 24 108 22-S
    Rings .25 ; 24 108 24-S
    Rings .50 ; 24 108 13-S

    Complete engine overhaul gasket set; 24 755 107-S

    Without a spec number you can only assume these rings will fit your engine, I'm pretty sure the gasket set will without problems.....


    Good Luck
     

Share This Page