1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum.

    Dismiss Notice

Risers for brass impacts

Discussion in 'Irrigation' started by enorl76, May 13, 2014.


Best value risers for brass impacts

  1. Straight up PVC (Sch 40, thickwall)

    0 vote(s)
  2. PVC Sch 80 thickwall

    0 vote(s)
  3. PVC with aluminum L channel, 2' below + 2' above ground

    1 vote(s)
  4. Galvanized riser 2' below grade, 2' above grade

    3 vote(s)
  1. enorl76

    enorl76 LawnSite Member
    Male, from Orlando, FL
    Messages: 213

    I'm trying to figure out whats better for several brass impacts that are about 2.5 feet above ground.

    PVC riser (most amount of swinging)
    PVC riser with L channel aluminum + cable ties to secure
    PVC riser with rebar? + cable ties to secure?
    Galvanized riser that starts about a foot into the ground
  2. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Messages: 50,592

    Some tweaker is just going to steal that brass impact head anyway.
  3. 1idejim

    1idejim LawnSite Fanatic
    Messages: 11,318

    Don't forget the tire.


    Posted via Mobile Device
  4. Sprinkus

    Sprinkus LawnSite Silver Member
    Messages: 2,310

    I'd use a metal riser or at least a schedule 80 nipple there, or better yet install a 12" rotor set to grade.

Share This Page