rooof vent

1675 Views 3 Replies 3 Participants Last post by riches139, Aug 19, 2003

riches139

Discussion Starter · Aug 8, 2003

Looking to put in a roof vent in my 7x16 enclosed. Problem is the roof is curved from side to side, and all the vents I've seen are flat based. Is there some sort of shim that the manufacturers use to install them?

Save

1 - 4 of 4 Posts

QuadRacer041

· #2 · Aug 8, 2003

nope its not a problem, just cut your holes and mount them then cawk(sp?) them in the sheet metal roof will flex no problem.

Save

myoder

· #3 · Aug 19, 2003

What about the side flow through vents? Are they sold at all or are they just installed at the dealer?

Save

riches139

Discussion Starter · #4 · Aug 19, 2003

Yes, I can buy those too. Already have the top vent. I know there's a way to do it, just haven't had time to get deep into it yet.
Thanks for answering.

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month