1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Separating Wheel Motor from Wheel Motor Mount

Discussion in 'Mechanic and Repair' started by RodneyK, Jan 11, 2014.

  1. RodneyK

    RodneyK LawnSite Senior Member
    Messages: 770

    Having a hard time getting the two apart. Anyone with a tip on how to do it? They are really stuck together.
  2. Restrorob

    Restrorob LawnSite Fanatic
    Messages: 11,029

    A 2x4 block and BFH knocking side to side.......
  3. meets1

    meets1 LawnSite Gold Member
    Messages: 3,850

    Try some heat....either torch or small handheld torch.
  4. RodneyK

    RodneyK LawnSite Senior Member
    Messages: 770

    Not sure how a big fuzzy hammer is going to help but I will try anything. Thanks for the tips. Can't wait until I can go them apart. It always amazes me what can slow you down on a project. One cotter pin 10 seconds, other cotter pin 10 minutes.
  5. Patriot Services

    Patriot Services LawnSite Fanatic
    Messages: 14,186

    No torches on motors. They are precision tolerance pieces with soft seals that will fry. Chemical penetrants, dead blow hammers and wood blocks.
    Posted via Mobile Device
  6. Breezmeister

    Breezmeister LawnSite Bronze Member
    Male, from South Jersey
    Messages: 1,739

    Yea, I know exactly what you mean :laugh: Like when you have to work on push spreaders, That is why when ever I can replace a cotter pin with a hair pin I do....

Share This Page