1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Simple way to clean your deck or change blades for your ZTR.

Discussion in 'Lawn Mowing' started by 4.3mudder, Aug 1, 2009.

  1. DeereHauler

    DeereHauler LawnSite Senior Member
    Messages: 604

    better than the tailgate method, i've been doin that for 10 years, and its just stupid and unsafe.... i just emailed the company to find out where i can get one
  2. 4.3mudder

    4.3mudder LawnSite Silver Member
    Messages: 2,227

    You can actually make one if you had some material laying around. Looks like all they used was a piece of pipe that was bent like a loppy l. And just have a plate with 4 holes mounted on the floor. Weld a U shaped piece on that plate so the pipe pivots inside the U. Make a similar piece on the ZTR and there ya go.
  3. Exmarkrules17

    Exmarkrules17 LawnSite Member
    Messages: 1

    I know it has been a while since there were any posts to this site. However I am not able to access the website any longer. Does anyone have any opinions on the ez lift? Good or bad?

  4. Blades Lawn Maintenance

    Blades Lawn Maintenance LawnSite Bronze Member
    Male, from Baton Rouge, La
    Messages: 1,229

    I'll have to try that out

Share This Page