Small Commercial Construction site

Discussion in 'Irrigation' started by Duekster, Mar 21, 2007.

  1. Duekster

    Duekster LawnSite Fanatic
    from DFW, TX
    Messages: 7,961

    Hello Guys and Gals,

    Looking at taking the next step on a small construction site. Total site is about an acre.

    The basics of the spec's are Irrigation lawn and beds.
    30 trees
    a few thousand bedding plants
    and 10,000 SF of sod.

    Also included the tilling of the site to add amendments to the soil along with the final grade.

    The irrigation system goes in first.

    Trees are big enough to require a 60" to 75" hole.

    So what is the best method of protecting the irrigation system when providing the soil preparation?

    I have seen folks do stub ups with PVC then add the heads right before laying the sod. The spec's do call for flex pipe as well.

    Any tricks of the trade to help prevent doing the riser work twice?

    BTW this is trench work.

    Many Thanks.
  2. Dirty Water

    Dirty Water LawnSite Fanatic
    Messages: 6,794

    We've done this a lot by just stubbing up the flex pipe swing joints. Leave a foot or so above grade, and add heads when they are done doing prep work.
  3. Duekster

    Duekster LawnSite Fanatic
    from DFW, TX
    Messages: 7,961


    That was kind of what I was thinking.
  4. Mike Leary

    Mike Leary LawnSite Fanatic
    Messages: 23,148

    Try to mark your valve boxes with scrap pipe, it's amazing how they get
    buried. I agree with Jon, make sure you tape the ends REALGOOD!

Share This Page