Lawn Care Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
i resently replaced the transmition in my truck, and when i was hooking it all back up i didn`t get the speedo cable in the holder on frame rail correctly. it then fell out onto my exshaust pipe and melted, but not in two. it stoped turning but was stil conenected on both ends. could something be stripped on one end or is there something that would give. I hope i don`t have to replace the plastic gear in the trans or the spedometer. what do you think?

frahmie
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top