Lawn Care Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
I have a 2000 Lazer-HP48" cutting deck. I'm trying to make a homemade striper we were talking about last week. I measured the inside brackets on the rear of deck & came up with 31". Do I need a 31" roller to fit into bracket space? Also 31" stripe isn't wide enough, do the tires count as part of the stripe? I would like the stripe to be close to the 48" pass I'm cutting.
Thanks guys- Joe
 

·
Registered
Joined
·
609 Posts
Joe,
Just check out the Turfflex website. Link is at top of this page.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top