t problem again

Discussion in 'Pesticide & Herbicide Application' started by vaacutabove, Jun 20, 2013.

  1. vaacutabove

    vaacutabove LawnSite Bronze Member
    Messages: 1,011

    Today my t has pressure but no flow to spray wond. Everything else's works good. Also what tips are y'all using broke mine today messing with it.need some help asap have a complex half done.
    Posted via Mobile Device

    CHARLES CUE LawnSite Silver Member
    Messages: 2,448

    Did you check the screen in the handle of the spray wand ? or is the nozzle plugged up ?

    I use a AI tip in mine and a teejet wand

    Does the main spray nozzle work

    Charles Cue
  3. RigglePLC

    RigglePLC LawnSite Fanatic
    Messages: 13,796

    Charles has the best suggestions. Open and close the valve a few times. The hose could be kinked, also. Perhaps best to replace the spray wand. Use one from an old back pack or hand sprayer in a pinch.
  4. FdLLawnMan

    FdLLawnMan LawnSite Bronze Member
    Messages: 1,251

    That wand on the T is junk ans I have told Turfco that. I replaced mine with Gunjet that I can out. Flat fan nozzle on. Pull the hose off the wand and see if you have flow. It almost has to be the wand unless the hose is kinked. What are you spraying?
    Posted via Mobile Device
  5. vaacutabove

    vaacutabove LawnSite Bronze Member
    Messages: 1,011

    Ended up replacing the wond works fine now thanks was using speedzone everything else was working fine thanks again guys.
    Posted via Mobile Device

Share This Page