1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

tips for 21 inch Toro

Discussion in 'Lawn Mowing' started by desert rose gardening, Apr 4, 2005.

  1. desert rose gardening

    desert rose gardening LawnSite Senior Member
    Messages: 387

    I found out years ago that I can adjust the wheel hights by holding the handel bar and useing my foot to do the hight adjustments rather than bending over and useing my hand. It a heck of a lot easer! Thought Id share that.
     
  2. Eddie B

    Eddie B LawnSite Senior Member
    from gone
    Messages: 859

    Make sure the blade isn't turning. I try to set the height before taking the toro's off of the trailer. This way they're closer to me. I'm lazy.
     
  3. TClawn

    TClawn LawnSite Silver Member
    Messages: 2,036

    I set the front one notch higher than the back. stresses the engine less on heavy growth that way. better bagging too.
     
  4. nt1

    nt1 LawnSite Senior Member
    Messages: 295

    Set the rear handle bars to your height. Low for shorter folks and high for taller folks. Basic info, but worth setting up right.
     
  5. lawnrangeralaska

    lawnrangeralaska LawnSite Senior Member
    Messages: 433

    put gas in your mower when it runs out
     
  6. Midwest Mower

    Midwest Mower LawnSite Member
    Messages: 27

    But put oil in before it runs out.
     
  7. Rick Jones

    Rick Jones LawnSite Senior Member
    from NY
    Messages: 427

    Or put them both in at the same time=2 stroke. :waving:
     
  8. A+ Lawncare

    A+ Lawncare LawnSite Senior Member
    Messages: 503


    or you'll be sry burning up a $700 mower.... friend of mine was cutting his own personal grass w/his dad's craftsmen ($4k lawn tractor, accordingly to him) w/o changing the oil.... blew it up..... says it cost as much to fix it up then buy a similar mower, i think he said about $2k to repair.....

    simple mistake could have been prevented...... :rolleyes:
     

Share This Page