Torque setting for blade bolts?

Discussion in 'Mechanic and Repair' started by bugspit, Apr 18, 2004.

  1. bugspit

    bugspit LawnSite Senior Member
    Messages: 767


    SCAPEASAURUSREX LawnSite Senior Member
    Messages: 835

    Why use longer bolts with doubles ???? You just need to remove a spacer so the cutting height is correct anyway.... If you use a longer bolt and change notheing else the cutting height will be about a 1/4" lower than it should be.........................
  3. metro-hp_48

    metro-hp_48 LawnSite Senior Member
    from TN
    Messages: 874

    On some mowers, a 1/4" longer bolt was needed. Not all by any means. Never ran doubles, and have never needed to.

    A search will answer any of your longer bolt questions.
  4. CNE

    CNE LawnSite Member
    Messages: 238

    German torque specifications- goodentight.
    Redneck torque specifications- tighten her til she strips, then back off a quarter turn.

Share This Page